Jeep OE Track Bar Bolt Kit 84-06 TJ/LJ/XJ/ZJ Clayton Off Road

Track Bar Bolt Kit Compatible with Jeep 1984-2006, TJ/LJ/XJ/ZJ Death Wobble Cure. Once you get the dreaded death wobble it only gets worse since many times it eggs out the lower track bar hole and therefore allows the track bar to move back and forth. This is a new flange bolt kit that is now used on all of our HD track bar kits. Our HD track bars use larger bushings which have a 9/16 through hole shown below. This will require you to drill out the OEM axle sidetrack bar location. Or you can buy this kit and our track bar bushing and weld on a new housing. 9/16-18 x 3 Grade 8 bolt, 2 washers and then all metal lock nut come welded to the 1/8 flange. Approximate torque spec = 146 ft-lbs NOTE : This kit uses a Top Lock - it will NOT screw on by hand. Start by hand, then use torque wrench. Uniquely shaped threads provide a vibration resistant friction fit, so the nut stays put. These all metal locknuts withstand higher temperatures than nylon insert locknuts. Top thread section is deformed to create two or three locking zones; they start easily by hand, then must be wrenched into final position. Grade C equivalent to Grade 8. IFI-100/107 Grade C. ANSI B1.1 UNC or UNF Class 2B thread requirement. Zinc plating, retards the corrosion rate in a normal atmosphere. Gold Zinc Plated For Corrosion Resistance Start by hand, then use a torque wrench.